Filter
Top Products
Assembly requires two people. Place all parts of the AIR STRIDER in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed. Read through all steps before
beginning assembly. As you assemble the AIR STRIDER, make sure that all parts are oriented as shown in the
drawings. Tighten all parts as you assemble them, unless instructed to do otherwise. Refer to the drawings
below to identify the small hardware used in assembly. Note: If a part is not found in the parts bag, check to
see if it has been pre-attached.
Assembly requires two adjustable wrenches , a hammer , and a phillips
screwdriver (not included).
4
ASSEMBLY
1. Read all instructions at the top of this page
before beginning assembly.
Refer to the drawing at the right and identify the
Left and Right Uprights (1, 2). Note the location of
the stop rods.
Turn the Crossbar (10) so the Rocker Arm (9) is at
the top. Attach the Crossbar to the Left Upright (1)
with two 3/8Ó x 4Ó Screws (44) and two 3/8Ó Flat
Washers (39). Do not tighten the Screws yet.
Attach the Crossbar to the Right Upright (2) in the
same manner.
Fig. 1
3/8" Nylon Locknut (43)Ñ2
3/8" Flat Washer (39)Ñ6
Plastic Spacer (41)Ñ2
3/8Ó Screw (42)Ñ2
3/8" x 4" Screw (44)Ñ4
Lock Washer (58)Ñ1
Bronze Bushing (16)Ñ4
Spacer (12)Ñ2
#8 x 3/4" Screw (23)Ñ3 #8 x 1/2" Screw (48)Ñ4
3/8" Axle Cap (40)Ñ4
1
Stop
Rods
44
39
10
9
2