7
5. Turn the Pedal Covers (27) upside-down. Remove
the paper backing from the adhesive strips on the
bottoms of the Pedal Covers.
Center one Pedal Cover (27) on the lower end of
the Left Leg (3). Press the Pedal Cover firmly into
place.
Attach the other Pedal Cover (27) to the lower
end of the Right Leg (4) in the same manner.
6. Note: Your Electronic Monitor (37) may look
different from the one shown in this manual, but
operates in exactly the same way. If your Monitor
has a battery cover (see figure 6), install batteries
as described in this step. If your Monitor does not
have a battery cover, see step 7 to install batteries.
Note: Two ÒAAÓ batteries (not included) are
required. Alkaline batteries are recommended.
Press the tab on the battery cover and remove the
battery cover. Insert two batteries into the Elec-
tronic Monitor (37). Make sure that the batteries
are turned as shown. Replace the battery cover.
7. Refer to figure 7a. Remove the two M4 x 16mm
Screws (48) from the monitor bracket and the
Electronic Monitor (37). Lift the Monitor off the
monitor bracket. Be careful not to pull the wire.
Refer to figure 7b. Insert two batteries into the
back of the Electronic Monitor (37). Make sure
that the batteries are turned as shown.
Refer to figure 7a. Reattach the Electronic Monitor
(37) to the monitor bracket with the two M4 x
16mm Screws (48).
8. Remove the two indicated M4 x 16mm Screws
(48) from the Right Upright (2). Attach the monitor
bracket to the Right Upright with the two Screws.
Note: If the Electronic Monitor (37) does not
operate properly, see HOW TO ADJUST THE
REED SWITCH on page 11.
37
Note: Your
Monitor may
look different
from the one
shown in this
manual, but
operates in
exactly the
same way.
Battery Cover
Fig. 8
Fig. 5
Monitor Bracket
48
2
37
27
3
4
27
Fig. 7a
48
Monitor
Bracket
Wire
37
37
Fig. 6
Fig. 7b