Filter
Top Products
6
3. Rest the Right Frame Section (6) on the floor and
hold it in the position shown.
Slide the Hip Pad (28) onto the Left Frame
Section (5). Slide the Left Frame Section onto the
Right Frame Section (6). Make sure to slide
both ends on at the same time. Use the rubber
mallet, if necessary, to make sure that the Left
Frame Section is fully seated on the Right Frame
Section.
Tighten two M5 x 16mm Screws (23) into the Left
and Right Frame Sections (5, 6).
Slide the Hip Pad (28) so it is centered on the Left
and Right Frame Sections (5, 6).
4. Refer to figure 4a. Position the Left and Right
Frame Sections (5, 6) around the Left and Right
Uprights (1, 2) as shown. Note: It will be neces-
sary to turn the Frame Sections at an angle in
order to slide them over the Uprights.
Refer to figure 4b. Attach the Left Frame Section
(5) to the Left Upright (1) with an M10 x 138mm
Bolt (42), a Plastic Spacer (41), and an M10
Nylon Locknut (43). Do not tighten the Nylon
Locknut yet. Attach the Right Frame Section (6)
to the Right Upright (2) in the same manner.
Tighten all parts used in steps 1 and 4.
Fig. 3
6
5
23
23
28
7
9
3
40
16
40
Pin
Pin
2. Refer to figure 2b. Slide a Finger Guard (54) onto
the Hex Bushing (33) and the pin on the Left Pivot
Bracket (7). Note: The Finger Guard may already
be attached.
Refer to figure 2a. Find the Left Link Arm (11),
which is labeled with a sticker. Make sure that there
are two 3/8Ó Bushings (16) in each end of the Link
Arm. Using a rubber mallet, tap one end of the Link
Arm onto the pin on the Left Pivot Bracket (7).
Make sure that the Link Arm is turned as shown
in figure 2c. Tap a 3/8Ó Axle Cap (40) onto the pin.
Tap the other end of the Left Link Arm (11) onto the
pin on the Rocker Arm (9). This will be a tight fit.
(Note: If necessary, pivot the Rocker Arm and the
Left Leg [3].) Tap a 3/8Ó Axle Cap (40) onto the pin.
Attach the other Finger Guard and the Right Link
Arm in the same manner (not shown).
Fig. 2a
11
Fig. 2c
Fig. 2b
54
33
7
7
Pin
Pin
16
11
Long
Side
Fig. 4a
5
5
42
1
1
2
2
41
43
6
6
Fig. 4b