Filter
Top Products
5
1
27
Tab
5. The Console (1) requires two “AAA” batteries. Alkaline
batteries are recommended. Press the indicated tab on
the Battery Cover (27), and remove the Battery Cover.
Insert two batteries into the two battery clips;
make sure
that the negative (–) ends of the batteries are touch-
ing the springs in the battery clips.
8. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or carpet,
place a mat under the treadmill.
34
33
35
36
2
5
6
34
33
4. Hold the Handrail (5) near the Left and Right Uprights (35,
36). Connect the Handrail Wire (2) to the Reed Switch
W
ire (6). Insert the Wires down into the Left Upright.
A
ttach the Handrail (5) to the Uprights (35, 36) with four
M8 x 15mm Bolts (33) and four M8 Washers (34). Be
careful not to pinch the Wires (2, 6).
See step 1. Tighten the four M8 Nylon Nuts (13).
Attach the Resistance Control (44) to the Right Upright
(36) with the M5 x 12mm Bolt (46) and the M5 Washer
(47).
4
Batteries
5
6. See drawing 6a. Hold the Console (1) near the Handrail
(5). Connect the wire on the Console to the Handrail
Wire (2). Attach the Console to the Handrail with two M4
x 12mm Screws (3).
Make sure that the wires are not
pinched.
See drawing 6b. Press the Battery Cover (27) back onto
the Console (1).
Make sure that the walking belt is properly tightened (see
SYMPTOM 3 on page 8).
7.
Remove the paper backing from the
Adhesive Clip (30).
Press the Adhesive Clip onto the Left Frame Endcap (24)
in the indicated location. Press the Hex Key (20) into the
Adhesive Clip.
27
3
1
2
6a
6b
1
44
46
47
30
20
24
7
5