Filter
Top Products
8
STEP BY STEP CONSOLE OPERATION
Make sure that the power cord is properly plugged in
(see HOW TO PLUG IN THE POWER CORD on page
7). Next, step onto the foot rails of the treadmill. Find
the clip attached to the key (see the drawing above).
Slide the clip onto your waistband. Follow the steps on
pages 8 and 9 to operate the console.
Insert the key fully into the power switch.
Note: The two dis-
plays will not
appear when the
key is first insert-
ed.
Press the On/Reset button.
The two displays
will appear. Note:
If batteries were
just installed, the
displays will
already appear.
Reset the speed control and start the walking
belt.
Slide the speed
control fully to the
left, to the
"RESET" position.
Next, slide the
control to the right
until the walking
belt begins to
move at a slow speed.
3
2
1
DIAGRAM OF THE CONSOLE
Key
Speed Control
Pulse Sensor
Monitor Display
Pulse Display
Clip
On/Reset
Button
Note: If there is a thin sheet of clear
plastic on the console, remove it.
Key
CAUTION:Before operating the con-
sole, read the following important precautions.
• Do not stand on the walking belt when turning
on the power.
• Always wear the clip while operating the tread-
mill. When the key is removed from the con-
sole, the power will shut off.
• After the speed control is moved, there will be
a pause before the walking belt begins to move.
• Adjust the speed in small increments until you
are familiar with the treadmill.
• To reduce the risk of electric shock, keep the
console dry. Avoid spilling liquid on the con-
sole and use only a sealed water bottle.