Filter
Top Products
TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please call our Customer Service Department toll-
free at 1-888-936-4266, Monday through Friday, 8h00 until 18h30 eastern time (excluding holidays).
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 9). Use only a CUL-listed surge suppressor,
rated at 15 amps, with a 1 mm
2
(14-gauge) cord of 1.5 m (5 ft.) or less in length. Important: The
treadmill is not compatible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the circuit breaker located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the circuit breaker has tripped. To reset
the circuit breaker, wait for five minutes and then
press the switch back in.
PROBLEM: The power turns off during use
SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see the drawing
above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Make sure the wires under the console are fully plugged in. (See assembly step 4 on page 6. WARN-
ING: Never disconnect or connect the wires while the treadmill power cord is plugged in.)
d. Remove the key from the console. Reinsert the key fully into the console.
PROBLEM: The incline of the treadmill does not change when the incline control is pressed
SOLUTION: a. Make sure that the wires under the console are fully plugged in. (See assembly step 4 on page 6.
WARNING: Never disconnect or connect the wires while the power cord is plugged in.)
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Check the batteries in the console. If the batteries need to be replaced, see BATTERY
INSTALLATION on page 8. Most problems are the result of drained batteries.
b. Remove the key from the console and UNPLUG
THE POWER CORD. Next, remove the screws from
the hood and carefully remove the hood. If neces-
sary, remove the left Resistance Knob (98) (see the
drawing at the bottom of page 13). Locate the Reed
Switch (44) and the Magnet (45) on the left side of
the Pulley (50). Turn the Pulley until the Magnet is
aligned with the Reed Switch. Make sure that the
gap between the Magnet and the Reed Switch is
about 3mm (1/8”). If necessary, loosen the Screw
(33) and move the Reed Switch slightly. Retighten the Screw. Re-attach the hood, and run the
treadmill for a few minutes to check for a correct speed reading.
Tripped
Reset
Tripped
Reset
c
45
44
33
Top
View
3mm
50
b
12