Weslo WATL16105.0 Treadmill User Manual


 
9. Make sure that all parts are properly tightened before
you use the treadmill. Keep the included hex key in a
secure place; the hex key is used to adjust the walking
belt (see page 14). To protect the floor or carpet, place a
mat under the treadmill.
8. Carefully lower the Handrails (6, 7) to the floor. Center the
Frame (55) between the Handrails, and tighten the four
Handrail Bolts (12). Then, raise the Handrails to the verti-
cal position.
See the inset drawing. Attach the Latch Assembly (41) to
the Left Handrail (7) with two 16mm Screws (87).
Make
sure that the Latch Assembly is oriented as shown.
See HOW TO CHANGE THE INCLINE OF THE TREAD
-
MILL on page 11. Adjust the Incline Legs to the desired
height, and fully insert the Incline Pins.
41
7
87
7. Attach the Console Back (4) to the Console (1) with four
16mm Screws (87). Note that there is a slot in the side of
the Console Back for the Wire Harness (22).
Make sure
that no wires are pinched.
1
87
4
87
87
Slot
6. Set the Console (1) on the Right Handrail (6) and the Left
Handrail (not shown). Start four Console Screws (70)
(
only two are shown) into the Console. A
fter you have
started all four Console Screws, tighten them.
Insert the excess Wire Harness (22) down into the Right
Handrail (6). Tighten the three plastic ties around the Wire
Harness, and then cut off the ends of the plastic ties.
22
Plastic
Ties
1
6
70
6
7
8
6, 7
55
12
8