Weslo WATL16105.0 Treadmill User Manual


 
7
5. Hold the Console Base (1) near the Right Handrail (6).
Touch the Right Handrail to discharge any static.
Insert the end of the Wire Harness (22) through the three
looped plastic ties. Next, press the end of the Wire
Harness into the connector on the back of the Console
Base (1) in the location shown. The end of the Wire
Harness should slide easily into the connector and
snap into place. If it does not, turn the end of the Wire
Harness and then insert it. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS TURNED ON.
Plastic
Ties
Connector
1
6
22
4. Have a second person lift and hold the front end of the
Frame (55). Hold a Frame Spacer (13) between the Right
Handrail (6) and the Frame. Attach the Right Handrail to
the Frame with a Frame Bolt (10), a Handrail Washer
(30), and a Handrail Star Washer (60).
Repeat this step on the left side of the treadmill.
13
55
60
10
30
6
5
3. With the help of a second person, raise the Handrails
(6, 7) so the Base (71) is flat on the floor.
Attach the Wheels (15) to the outer sides of the Base
(
71) with two Wheel Bolts (14) and two Nuts (17). D
o not
overtighten the Nuts; the Wheels should turn freely.
Position the treadmill Frame (55) between the Handrails
(6, 7) as shown. See the inset drawing. Locate the wire in
the lower end of the Right Handrail (6). Using the in-
cluded plastic tie, secure the wire to the Wire Harness
(22). Next, pull the opposite end of the wire until the Wire
Harness is routed through the Right Handrail. Then, dis-
connect and discard the wire.
22
71
17
15
14
6
55
3
22
6
Tie
Wire
4
7
22