Filter
Top Products
6
50
8
27
6. Identify the Left Handlebar (6), which is marked with a
sticker. Insert the Left Handlebar into one of the
Handlebar Arms (5); make sure that the Handlebar
Arm is turned so the hexagonal holes are on the
indicated side. Attach the Left Handlebar to the
H
andlebar Arm with two M6 x 38mm Button Bolts (50)
a
nd two M6 Nylon Locknuts (27).
M
ake sure that the
Nylon Locknuts are inside of the hexagonal holes.
Do not fully tighten the Button Bolts yet.
Apply a small amount of the included grease to the left
axle on the Upright (2).
Make sure that there are two Small Handlebar
Bushings (49) in the Left Handlebar (6). Slide a
Handlebar Spacer (47) and the Left Handlebar onto the
left axle on the Upright (2) as shown.
Make sure that the
Handlebar Spacer is turned so the curved side is fac-
ing the Upright.
Tap an Axle Cap (14) onto the axle.
Repeat this step to assemble the Right Handlebar (8)
and the other Handlebar Arm (5).
Grease
6
47
14
49
5
2
5
6
7
36
11
13
7. Identify the Left Pedal Arm (11). Attach a Pedal (13) to
the Left Pedal Arm with two M6 x 48mm Flat Head
Screws (36).
Attach the other Pedal to the Right Pedal Arm (not
shown) in the same way.
Hexagonal
Holes