Filter
Top Products
6. Attach the Storage Latch (14) to the left Upright (11) with
two Screws (33). Be careful not to overtighten the
Screws.
Place the Weights on the Weight Rack (90) with the
3 lbs. Weights (79) in the center of the Rack and 2 lbs.
Weights next, followed by the 1 lbs. Weights.
7. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the
floor or carpet, place a mat under the treadmill.
33
14
11
79
90
6
5. Cut and remove the plastic tie holding the Wires (21) to
the right Upright (11).
Place the Console Base (46) on the right and left
Uprights (11) (only the right Upright is shown). Route the
Wires (21) through the Cable Tie loop. Connect the two
indicated Wires (21) to the three connectors in the
Console Base (46). Important: Make sure the Wires are
fully inserted. The small wire connectors should slide
easily and “snap” into place. If they do not, turn and try
again. WARNING: Do not disconnect or connect the
Wires while the treadmill power cord is plugged in.
Pull the Cable Tie tight. Cut off the end of the Cable Tie.
Loosely thread four Screws (33) into the Uprights and the
Console Base. After all four Screws have been started,
tighten the Screws until they are snug; do not over-
tighten the Screws.
33
Plastic Tie
Cable
Tie
21
Connectors
46
11
5
3. Attach the Weight Rack (90) to the Uprights (11) with the
two Rack Washers (41) and Rack Bolts (89). Note: If nec-
essary, spread the Uprights apart (11) to align the holes in
the Weight Rack with the holes in the Upright.
Insert the Right Handrail (88) into the upper end of the
right Upright (11), with the lower end of the Handrail to the
side of the Extension Leg (34) as shown. Have a second
person hold the Right Handrail until step 4 is completed.
11
11
89
89
41
90
34
88
41
3
4. Attach the lower end of the Right Handrail (88) to the
Extension Leg (34) with a Handrail Bolt (91), Handrail
Washer (92), and Handrail Nut (93) as shown. Note: It
may be necessary to push on the lower end of the
Handrail to align the hole in the Handrail with the hole in
the Extension Leg.
Attach the Left Handrail to the left Extension Leg (not
shown) as described above.
4
92
91
93
34
88
6
21