Filter
Top Products
4
Assembly requires two people. Place all parts of the EASY STRIDE in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Read all steps before beginning assembly. As you assemble the EASY STRIDE, make sure that all parts are
oriented as shown in the drawings. Make sure to tighten all parts as you assemble them, unless instructed to do
otherwise. Refer to the drawings below to identify the small parts used in assembly. Note: If a part is not found
in the parts bag, check to see if it has been pre-attached.
Assembly requires two adjustable wrenches , a hammer , and a phillips
screwdriver (not included). A small amount of soapy water is also required.
ASSEMBLY
3/8Ó Nylon Locknut (32)Ñ8
Lock Washer (16)Ñ1
3/8Ó x 2Ó Carriage Bolt (35)Ñ8
#8 x 3/4Ó Screw (28)Ñ5
Link Arm Bushing (14)Ñ2
3/8Ó Washer (19)Ñ2
3/8Ó x 1 1/4Ó Screw (18)Ñ2
3/8Ó Spacer (20)Ñ2
3/8Ó Axle Cap (21)Ñ2