Filter
Top Products
1. Note that the Right Handrail and the Console Base
(not shown) are connected to the treadmill by a Wire
Harness. During assembly steps 1 through 5, be
careful not to pull on or damage the Wire Harness.
With the help of a second person, carefully lay the
treadmill on its side. Position one of the Base Legs
(38) on the base of the Upright (31) as shown. Make
sure that the Base Leg Pads (41) and the Front
Wheel (39) are in the indicated positions. Attach the
Base Leg with two 3/8Ó x 2Ó Bolts (43), two 3/8Ó
Washers (44) and two 3/8Ó Nuts (34).
Carefully turn the treadmill onto its other side.
Assemble the other Base Leg (38) as described.
With the help of a second person, carefully raise the
treadmill to the upright position so the Base Legs
(38) are resting flat on the floor.
2. Refer to HOW TO LOWER THE TREADMILL FOR
USE on page 11. Follow the instructions in step 2 to
lower the treadmill.
Without removing the tape from the Latch (18), hold
the Latch against the left Upright (31) as shown.
Attach the Latch to the left Upright with the four
shorter Screws (24). Make sure that the Screws
are tight, but do not overtighten them; if the
Screws are overtightened, the Latch will not
slide smoothly. After the Latch is attached, remove
any visible tape.
Note: The inset drawing shows how the parts of the
Latch (18) fit together.
3. Cut the plastic ties that hold the cage nuts in each
Handrail (30, 32 not shown).
Position the Left Handrail (30) on the left Upright
(31). Thread a 1/4Ó x 1Ó Bolt (23) with a 1/4Ó Washer
(22) into the upper end of the left Upright and the
Left Handrail. Do not tighten the Bolt yet.
Thread a 1/4Ó x 1Ó Bolt (23) with a 1/4Ó Washer (22)
into the lower end of the Left Handrail (30) and the
left Upright (31). Do not tighten the Bolt yet.
1
5
43
44
41
38
39
31
34
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small
parts used in assembly. Assembly requires the included allen wrench and your own phillips screw-
driver , two adjustable wrenchs , and scissors .
2
3
24
31
18
Spacer
Springs
Latch
Bracket
23
22
30
23
31
22