Weslo DS10 Treadmill User Manual


 
11
DIAGRAM OF THE CONSOLE
Clip
Key
Speed Control
Monitor Displays
with the negative (–) ends of the batteries touching the
springs. Close the battery cover, push up on the tab,
and then push the tab forward as shown. Make sure
that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 10.)
Stand on the foot pads of the treadmill. Find the clip at-
tached to the key, and slide the clip onto the waistband
of your clothes. Next, insert the key into the console.
Test the clip by carefully taking a few steps back-
ward until the key is pulled from the console. If the
key is not pulled from the console, adjust the po-
sition of the clip as needed.
Follow the steps on page 12 to operate the console.
BATTERY INSTALLATION
The console requires two "AA" batteries (not in-
cluded). Alkaline batteries are recommended. To in-
stall batteries, open the battery cover as shown at the
right. Press two batteries into the battery compartment,
CAUTION:Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing above)
while operating the treadmill. When the key
is removed from the console, the walking
belt will stop.
• Adjust the speed in small increments.
• The training zones marked around the speed
control are general guidelines only. See page
18 for more information.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable water
bottle.
Batteries
Tab
Battery
Cover
If there is a sheet of clear plastic on
the console, remove the plastic.