Filter
Top Products
7
2. Slide the two Wheel Housings (45) onto the Base
(
52). Attach each Wheel Housing with two Wheel
Housing Bolts (13), two Wheel Housing Washers
(32), and two Wheel Housing Nuts (43).
2
52
13
32
3
2
45
43
13
32
32
45
4
3
3. Position the Base (52) as close to the front of the
treadmill as possible.
See drawing 3a. Locate the wire tie in the Right
Upright (54). Tie the wire tie securely to the con-
nector on the end of the Wire Harness (98).
Next, pull the opposite end of the wire tie out of
the upper end of the Right Upright (54), until the
Wire Harness is routed completely through the
Right Upright. Secure the Wire Harness to the
upper end of the Right Upright so that it will not
fall inside.
See drawing 3b. Press the indicated Grommet
(49) into the Right Upright (54).
52
3
98
54
54
54
49
98
52
Wire Tie
3b
3a
98