Filter
Top Products
6
3. Carefully rotate the Console Base (45) to the posi-
tion shown. Insert two Handrail Bolts (77) through
the Console Base and the Upright (37). The
Handrail Bolts must be inserted from the inside
as shown. Attach a Handrail Nut (86) and Handrail
Washer (85) to each Handrail Bolt.
Tighten all four Handrail Bolts (77) as tightly as
possible. Carefully lift up and push down on the
handrails to make sure that the Console Base
(45) does not move. Regularly inspect and tight-
en all four Handrail Bolts.
4. Attach the Frame Guide (66) to the left side of the
Frame (21) with two Frame Guide Screws (44) as
shown. Note: Be careful not to overtighten the
Screws. Make sure that the thick end of the
Frame Guide is at the bottom.
5. Remove the backing from the Adhesive Clip (2).
Press the Adhesive Clip onto the base of the Upright
(37) in the indicated location. Press the Allen
Wrench (35) into the Adhesive Clip.
6. The Console (49) requires two "AA" batteries (not
included); alkaline batteries are recommended.
Open the Battery Cover (48) as shown. Press two
batteries into the battery compartment, with the nega-
tive (Ð) ends of the batteries touching the springs.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the
inset drawing. Be sure that the tab locks into place.
7. Make sure that all parts are properly tightened
before you use the treadmill. The use of the remain-
ing parts will be described in other sections of this
manual. To protect the floor or carpet from dam-
age, place a mat under the treadmill.
4
5
21
35
37
2
66
Thick end
44
37
45
86
85
77 77
86
85
77
77
37
45
Handrails
3
6
48
49
Batteries
Battery
Cover Tab