Filter
Top Products
66
5
38
8
8. Attach the Storage Latch (66) to the left Upright (38)
with two 3/4” Screws (5).
9. Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep
the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page
13). To protect the floor or carpet, place a mat under the treadmill.
87
53
10
5
4
5
5
7
7. Set the Console (11) in the Console Base (87). Make sure
that no wires are pinched. Insert as much of the Wire
Harness as possible (53) down the hole in the right
Handrail (4). Securely tighten the plastic tie nearest the
right Handrail. Pull any excess Wire Harness between
the plastic ties tight and tighten the other plastic tie. Cut off
the ends of the plastic ties. Cover the Wire Harness with
the Wire Cover (10), and route the Wire Harness out of the
hole in the side of the Wire Cover. Attach the Wire Cover
to the back of the Console Base with two 3/4” Screws (5).
Do not overtighten the Screws.
Make sure that no wires are pinched before you
attach the Console (11) to the Console Base (87).
Tighten the remaining four 3/4” Screws (5) into the
Console Base and the Console. Do not overtighten the
Screws.
7
11
6. Hold the Console (11) near the Console Base (87).
Touch the right Handrail (4) to discharge any static.
Locate the two wires in the Wire Harness (53) that have
L-shaped connectors on the ends. Press the connectors
onto the two tabs on the switch shown in inset drawing
6a. Connect the other two wires in the Wire Harness to
the back of the Console (87) in the locations shown by
the arrows in drawing 6. If the connectors do not fit
together easily, rotate them and then connect them.
11
53
6
87
6a
Tabs
Ties
4