Filter
Top Products
6
3. If there are plastic ties in the brackets on the Handrails
(4), remove the plastic ties. Hold one of the Handrails
near the right Upright (38) as shown. Insert the Wire
Harness (53) up through the bracket on the Handrail and
out of the round hole in the side of the Handrail. If neces-
sary, use needlenose pliers to pull the Wire Harness out
of the hole. Be careful not to damage the Wire
Harness.
Insert the brackets on the Handrails (4) into the upper
ends of the Uprights (38).
Finger tighten four 1” Bolts (16) with Handrail Washers
(40) into the Uprights (38) and the Handrails (4).
40
53
38
40
38
Connectors
16
40
16
4
16
4
16
Bracket
3
5
Plastic Ties
5
4
4
53
87
4
4. Set the Console Base (87) on the Handrails (4). Thread
four 3/4” Screws (5) into the Handrails and the Console
Base. After you have started all four Screws, tighten the
Screws until they are snug; do not overtighten the
Screws.
Firmly tighten, but do not overtighten, the 1” Bolts
(not shown) used in step 3.
Insert the Wire Harness (53) through the two indicated
plastic ties on the Console Base (87) and up through the
hole in the Console Base.
12
Hinges
87
5
5. Insert the Battery Cover (12) into the Console Base (87),
with the hinges in the position shown. The Battery Cover
should pivot down, away from the Console Base.