Filter
Top Products
15
HOW TO USE A PRESET WORKOUT
1. Insert the key into the console.
See HOW TO TURN ON THE POWER on page 13.
2. Select a preset workout.
To select a preset work-
out, press the Select
Workout button repeat-
edly until the number of
the desired workout ap-
pears in the upper dis-
play. Note: The name, number, and profile of each
workout is listed on the console.
When you select a preset workout, the incline level
of the workout will flash in the lower left display, the
speed setting will flash in the upper display, and
then the workout duration will appear in the lower
left display.
3. Select the duration of the workout if desired.
If you have selected workout 1, 2, or 3, you can set
the duration of the workout to a time between 15
and 45 minutes, in increments of 5 minutes. To set
the duration of the workout press the Set Time in-
crease or decrease button until the desired time is
selected. The new workout settings will appear in
the displays.
4. Start the walking belt.
Press the Go button or the Speed increase button
to start the workout. A moment after you press the
button, the treadmill will automatically adjust to the
first speed and incline settings of the workout. Hold
the handrails and begin walking.
Each workout is divided into 30 one-minute seg-
ments, unless you have changed the duration of
the workout (see step 3). One speed setting and
one incline setting are programmed for each seg-
ment. Note: The same speed setting and/or incline
setting may be programmed for consecutive seg-
ments.
Tones will sound at the end of each segment.
T
hree seconds before the speed and/or incline of
the treadmill is about to change, the speed and/or
incline will flash in the display and a series of tones
will sound to alert you. The treadmill will then auto-
matically adjust to the speed and/or incline settings
for the next segment.
If you have selected workout 4, 5 or 6, you will be
prompted to use the crosswalk arms. When the
crosswalk indicator on the console lights up, move
the crosswalk arms forward and backward as you
walk on the treadmill. This action exercises your
arms, shoulders, and back for a total body workout.
The workout will continue in this way until the last
segment ends. The walking belt will then slow to a
stop.
If the speed or incline setting is too high or too low
at any time during the workout, you can manually
override the setting by pressing the speed or in-
cline buttons; however, when the next segment
of the workout begins, the treadmill will auto-
matically adjust to the speed and incline set-
tings for the next segment.
To stop the workout at any time, press the Stop
button. To restart the workout, press the Go button.
The walking belt will begin to move at 1 mph. When
the next segment of the workout begins, the tread-
mill will automatically adjust to the speed and in-
cline settings for the next segment.
5. Follow your progress with the displays.
See step 5 on page 14.
6. Measure your heart rate if desired.
See step 6 on page 14.
7. When you are finished exercising, remove the
key from the console.
See step 7 on page 14.