5
4
6
2
30
16
17
7
26
4. Slide a Metal Cap (30) onto the indicated shaft on
the Base (2). Make sure that the open side of the
Metal Cap is facing the Base.
Apply grease to the shaft on the Base (2).
Identify the Right Pedal Leg (7) which has a Magnet
(26) attached to it. Apply grease to the Pedal Leg
Bushings (16) that are in the Right Pedal Leg.
Slide the Right Pedal Leg (7) onto the shaft on the
Base (2). Tap a 3/4Ó Axle Cap (17) onto the shaft.
Repeat this step to attach the Left Pedal Leg (6).
Apply Grease
to Shaft
Apply
Grease
5. Slide the Upright (1) onto the threaded bolts in the
Base (2). Make sure that the Upright is angled in
the direction shown. Attach the Upright with four
M10 Locknuts (15).
1
2
15
15
5
2. Press a Stabilizer Endcap (13) onto each end of the
Short Stabilizer (3).
Attach the Short Stabilizer (3) to the Base (2) with
two M10 x 65mm Hex Head Bolts (24), two
Washers (25) and two M10 Locknuts (15).
3. Attach a Pedal (11) to each Pedal Leg (6, 7) with
four M4 x 10mm Screws (28).
11
6
28
3
2
25
15
15
2
3
13
13
25
24