6.
Attach the Storage Latch (14) to the left Upright (11) with
two Screws (33).
Be careful not to overtighten the
Screws.
Place the two 3-lb. Weights (79) in the center of the
Weight Rack (90). Next, place the 2-lb. Weights and the
1-lb. Weights (not shown) in the Weight Rack.
7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
33
14
11
79
90
6
5. Cut and remove the plastic tie on the right Upright (11).
Place the Console Base (46) on the right and left
Uprights (11) (only the right Upright is shown). Wrap the
indicated cable tie around the Wires (21) or pull the
Wires through the cable tie loop. Pull the cable tie tight
and cut off the end of the cable tie.
Connect the two indicated Wires (21) to the two connec-
tors in the Console Base (46). Important: Make sure
the Wires are fully inserted. WARNING: Do not dis-
connect or connect the Wires while the treadmill
power cord is plugged in.
Loosely thread four Screws
(33) into the Uprights and the Console Base. After all
four Screws have been started, tighten the Screws
until they are snug; do not overtighten the Screws.
33
Plastic Tie
Cable
Tie
21
Connectors
46
11
5
3. Attach the Weight Rack (90) to the Uprights (11) with the
two Rack Bolts (89) and Rack Washers (41). Note: If nec-
e
ssary, spread the Uprights apart slightly to align the
holes in the Weight Rack with the holes in the Uprights.
Insert the Right Handrail (88) into the upper end of the
right Upright (11), with the lower end of the Handrail to the
s
ide of the Extension Leg (34) as shown. Have a second
person hold the Right Handrail until step 4 is completed.
1
1
89
89
41
90
34
88
41
11
3
4. Attach the lower end of the Right Handrail (88) to the
Extension Leg (34) with a Handrail Bolt (91), a Handrail
Washer (92), and a Handrail Nut (15) as shown. Note: It
may be necessary to push on the lower end of the
Handrail to align the hole in the Handrail with the hole in
the Extension Leg.
Attach the Left Handrail to the left Extension Leg (not
shown) as described above.
4
92
91
15
34
88
6