Filter
Top Products
9
12. Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep
the included hex key in a secure place; the hex key is used to adjust the walking belt (see page 17).
T
o pro
-
tect the floor or carpet, place a mat under the treadmill.
10. Lower the Handrails (53, 59) until they are touching the
floor.
See 10a. Position the Handrails (53, 59) so the treadmill
Frame (79) is centered between them.
Firmly tighten the four 2 1/2” Bolts (65), the two 2” Bolts
(62), and the two 3 1/2” Bolts (70). Be careful not to
overtighten the Bolts.
53
53, 59
79
70
79
59
Top View
10
10a
65
62
65
9. Securely tighten a plastic tie around the Wire Harness
(60) and under the indicated hook on the Console (55) to
p
revent the Wire Harness from slipping. Tighten the plas-
tic tie and cut off the end.
See drawing 9a. Set the Console (55) in the Console Base
(52).
Make sure that the Wire Harness (not shown) is
not pinched. Next, set the Console Base on the Handrails
(53, 59). Insert as much of the Wire Harness as possible
into the hole in the Right Handrail (59). See step 7.
Tighten the plastic tie and cut off the end.
Loosely thread six 3/4” Screws (2) into the Console Base
(52) and the Console (55). Loosely thread four 3/4”
Screws into the Handrails (only two Screws are shown).
Start all ten Screws and then tighten them; do not
overtighten the Screws.
55
Tie
Hook
2
2
2
52
55
59
53
60
2
48
53
Knob
Spring
Large Hole
Collar
Pin
11.Orient the Latch Housing (48) so the large hole is on the
indicated side.
Attach the Latch Housing to the Left
Handrail (53) with two 3/4” Screws (2);
start both Latch
Screws and then tighten them.
Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are two col-
lars, place one on each side of the spring.) Next, insert
the pin into the Latch Housing (48).
Then, tighten the
knob back onto the pin.
9
9a
1
1