Filter
Top Products
8
10. Press a 1 1/2Ó Square Inner Cap (33) into the end of
the Seat Frame (36).
Insert two 5/16Ó x 2 3/4Ó Bolts (67) through the
Support Plate (27) and the indicated holes in the
Front Upright (42). Place the mounting bracket on the
Seat Frame (36) over the two Bolts. Tighten a 5/16Ó
Nylon Locknut (53) onto each Bolt. Make sure the
Support Plate (27) is oriented as shown.
Press the Angle Cap (62) onto the end of the rod on
the Support Plate (27). Make sure that the Angle
Cap is angled as shown in the inset drawing.
67
53
Rod
42
36
Bracket
27
53
33
10
11. Open the parts bag labeled ÒARM ASSEMBLY.Ó
Press a Plastic Bushing (7) onto each welded tube on
the Press Frame (12).
Lubricate the 3/8Ó x 8Ó Bolt (59). Attach the Press
Frame (12) to the Base (8) with the Bolt and a 3/8Ó
Nylon Locknut (57).
Arm Assembly
59 Lubricate
Welded Tubes
12
7
57
8
11
9. Feed both Wire Ties (23) into the Wire Tie Blocks (82)
that are pre-assembled to the Base (8). Carefully
position the wire bundle over the Wire Tie Blocks and
secure the wires to the Base with the Wire Ties.
Note: The other end of the wire bundle will be
attached to a shroud in a later step. Make sure that
some slack is left between the wires and the
Weight Mechanism (26, not shown) for this pur-
pose.
9
23
82
8
Wires
8. Attach the indicated end of the Console Cord (83) to
the indicated end of the wire bundle. Make sure that
the Console Cord is attached exactly as shown.
8
83
26
Wires
62