Filter
Top Products
15
34. Attach the Curl Pad (24) to the Curl Post (10) with
two 1/4Ó x 3/4Ó Screws (17).
Slide the Curl Post (10) onto the Seat Frame (36) so
each of the welded brackets is between the Seat
Frame and the bracket on the Leg lever (29). Secure
the Curl Post with the 5/16Ó x 2Ó Knob (72).
Make sure the Leg Lever (29) can be turned freely
after the Curl Post (10) is mounted.
35. Insert the three 1 1/2Ó Square Inner Caps (33) into
the Console Base (61).
Attach the Console Upright (94) to the Console Base
(61) with two 1/4Ó x 5/8Ó Screws (95).
Attach the Console (39) to the the Console Upright
(94) with four #8 x 1/2Ó Screws (87).
36. Plug the end of the Console Cord (83) into the
Console (39).
Note: When the Shroud (not shown) is attached in
step 39, the Console Cord (83) should be pressed
between the bottom of the Shroud and the Base (8).
33. Press two 3/4Ó Round Inner Caps (34) into each Pad
Tube (28).
Insert one Pad Tube (28) into the Seat Frame (36).
Slide a Foam Pad (30) onto each end of the Pad
Tube.
Insert the other Pad Tube (28) into the Leg Lever
(29). Slide a Foam Pad (30) onto each end of the
Pad Tube.
33
30
30
30
28
28
30
34
34
36
29
34
17
36
29
10
72
24
Welded
Brackets
35
87
33
33
33
95
95
94
61
39
36
83
8
39
34
34