Filter
Top Products
75
6
2. Attach a Wheel (31) to the outside of the Base (1)
with an M10 x 108mm Bolt (81), three M10
W
ashers (75), and an M10 Nylon Locknut (76).
Do not overtighten the Nylon Locknut; the
W
heel must be able to turn easily.
Attach the other Wheel (not shown) in the same
manner.
2
1
31
75
76
75
81
3. Press a 38mm x 64mm Inner Cap (41) into each
end of the Cross Tube (11).
Orient the Cross Tube (11) as shown, with the
welded tubes at the bottom. Attach the Cross
Tube to the Upright (3) with two M10 x 140mm
Carriage Bolts (73), two M10 Washers (75), and
two M10 Nuts (47).
3
41
3
73
41
Welded
Tube
11
47
5. Lubricate an M10 x 103mm Bolt (66) with grease.
Attach the Bench Rail (5) to the Upright (3) with
the Bolt and an M10 Nylon Locknut (76). Do not
overtighten the Locknut; the Bench Rail must
be able to pivot easily.
T
ighten the Storage Knob (30) into the Upright (3)
and the Bench Rail (5).
4. Press the 38mm x 76mm Dome Cap (87) into the
indicated end of the Bench Rail (5). Press a
38mm x 76mm Inner Cap (34) into the other end
of the Bench Rail.
Press two 50mm Square Outer Caps (27) onto
the ends of the Front Leg (6).
Attach the Bench Rail (5), with the hole on the
top, to the Front Leg (6) with two M10 x 68mm
Screws (61).
4
5
5
34
Hole
87
27
27
61
6
76
30
66
Lubricate
Insert the bolt
through this hole
5
3