Filter
Top Products
8
9. Press two 38mm x 50mm Inner Caps (41) into
the ends of the Cross Frame (11).
Orient the Cross Frame (11) as shown, with the
welded tube near the top. Attach the Cross Frame
(11) to the Upright Base (3) with two M10 x
102mm Carriage Bolts (73), two M10 Washers
(75), and two M10 Nylon Locknuts (76).
11. Lubricate the M10 x 78mm Bolt (66). Attach the
Bench Frame (5) to the Upright Base (3) with the
Bolt and an M10 Nylon Locknut (76). Do not
overtighten the Locknut; the Bench Frame
must be able to pivot easily.
Tighten the Knob (30) into the Upright Base (3)
and the Bench Frame (5).
12. Attach the Leg Lever Bumper (55) to the Front
Leg (6) with the M4 x 19mm Screw (62).
Press two 45mm Square Inner Caps (42) into the
ends of the Leg Lever (7).
Lubricate the M10 x 68mm Bolt (64). Attach the
Leg Lever (7) to the Front Leg (6) with the Bolt
and an M10 Nylon Locknut (76). Do not over-
tighten the Locknut; the Leg Lever must be
able to pivot easily.
10. Press a 38mm x 50mm Inner Cap (41) into the
top of the Front Leg (6). Press the Front Leg Foot
(27) onto the bottom of the Front Leg. Note that
the front of the Front Leg Foot slants more
than the back.
Press a 38mm x 50mm Inner Cap (41) into the
end of the Bench Frame (5).
Attach the Bench Frame (5) to the Front Leg (6)
with two M10 x 53mm Carriage Bolts (61) and
two M10 Nylon Locknuts (76).
9
10
11
12
41
3
73
41
Welded
Tube
11
76
75
75
5
41
76
41
27
61
6
76
30
66
Lubricate
5
3
64
76
6
7
42
62
55
42
Lubricate