Filter
Top Products
13
28. Slide the four Foam Pads (26) onto the tubes on
the Front Leg (6) and the Leg Lever (7). Press
the four 19mm Round Inner Caps (78) into the
ends of the tubes.
29. Attach the “FLEX CTX 60” exercise decal to the
Upright Base (3) and the Upright (4). The decal
should be centered on the Upright Base and
Upright, and the top of the decal should be six
inches below the Top Frame (9). Be careful
not to wrinkle the decal.
30.
Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull the long cable a few times to be sure that it move smoothly over the
pulleys. If the cable does not move smoothly, find and correct the problem. IMPORTANT: If the cables are
not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM
on page 17 for proper cable routing.
28
29
78
78
26
26
7
6
26
78
78
4
9
6”
3
26