Filter
Top Products
7
7. Attach the Seat (9) to the brackets on the Frame
(4) with four M6 x 16mm Screws (22).
8. Press two 19mm Round Inner Caps (14) into
each Pad
T
ube (13). Slide the Pad Tubes through
the holes in the Leg Lever (6). Slide a Foam Pad
(12) onto each side of each Pad Tube.
14
14
12
12
8
9. Make sure that all parts are properly tightened
before you use the weight bench. The use of
all remaining parts will be explained in ADJUST-
MENTS, beginning on the next page.
14
6
13
22
4
9
22
7
6. Press two 25.4mm Inner Caps (15) into the ends
of the Support Rod (11). Slide the Support Rod
through a set of holes in the Uprights (1) and turn
it to the locked position.
See the inset drawing. With the help of a sec-
ond person, slide the indicated ends of the
Backrest Tubes (7) onto the welded axle on the
Frame (4).
Attach the left Backrest Tube (7) to the Backrest
(8) with a fourth M6 x 38mm Screw (23) and M6
Washer (25). Tighten all four Screws in the
Backrest.
Rest the Backrest (8) on the Support Rod (11).
Tighten the M8 Nylon Locknuts (24) used in
steps 1–3.
1
1
15
15
11
23
25
8
6
7
7
7
4
4
Welded Axle