Filter
Top Products
16
39. Wrap the Weight Cable (72) around a 3 1/2” Pulley
(24). Attach the 3 1/2” Pulley and a Cable Trap (25)
between the lowest holes in the Adjustable Pulley
Plates (23) hanging from the Ab Cable (47) with a
3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50)
that was removed in step 28. Be sure that the
Cable Trap is turned to hold the Cable in place.
40. Remove the preassembled 3/8” x 1 3/4” Bolts (57)
from the Small Pulley Plates (22).
Wrap the Weight Cable (72) around a 3 1/2” Pulley
(24). Attach the 3 1/2” Pulley between two Small
Pulley Plates (22) with a 3/8” x 1 3/4” Bolt (57) and
a 3/8” Nylon Locknut (50).
41. Wrap the Weight Cable (72) around a 4 1/2” Pulley
(82). Attach the 4 1/2” Pulley to the bracket on the
Press Top Frame (9) with a 3/8” x 2” Bolt (54) and a
3/8” Nylon Locknut (50).
42. Place a 1/2” Flat Washer (11) on top of the Weight
Tube (17).
Thread a 1/2” Plain Nut (45) halfway onto the bolt
on the Weight Cable (72). Screw the bolt on the
Weight Cable into the Weight Tube (17) a couple of
turns.
Tighten the 1/2” Plain Nut (45) down onto the 1/2”
Flat Washer (11).
39
40
41
23
50
47
72
22
54
24
82
54
24
50
57
72
9
72
17
45
11
42
50
Bracket
72
25