Filter
Top Products
6
2. Attach the Bench Frame (1) to the Front Leg (2)
with two M10 x 65mm Bolts (40), two M10
W
ashers (44), and two M10 Nylon Locknuts (43).
Do not tighten the Locknuts.
4. Attach the Weight Tube (16) inside the Leg Lever
(3) with an M8 x 58mm Bolt (52), two M8
Washers (56), a 10mm Spacer (32), and an M8
Nylon Locknut (55).
Press the 25mm Round Angled Cap (28) onto the
Weight Tube (16).
Grease an M10 x 68mm Bolt (54).
Attach the Leg
Lever (3) with the Bolt and an M10 Nylon Locknut
(43).
Do not overtighten the Locknut; the Leg
Lever must be able to pivot easily.
5. Orient the Backrest Frames (12) with the indicat-
ed holes closer to the bottom.
Attach the Backrest
Frames to the Backrest Bracket (10) with four M6
x 40mm Bolts (49), four M6 Washers (48), and
four M6 Nylon Locknuts (51). Do not tighten the
Locknuts.
3. Attach the Bench Frame (1) to the Crossbar (4)
with two M10 x 81mm Bolts (41) and two M10
Nylon Locknuts (43).
Tighten the M10 Nylon Locknuts (43) used in
steps 1 through 3.
1
2
40
40
44
43
2
3
1
41
43
41
4
54
2
43
3
28
16
56
52
32
56
55
Grease
4
5
12
48
48
Holes
49
10
48
48
49
51
51