Filter
Top Products
9
15. Route the Long Cable (34) up through the Weight
Frame (10), over a 3 1/2” Pulley (27), and back
down through the Weight Frame. Attach the
Pulley to the Weight Frame with an M10 x 75mm
Bolt (31), two Short Spacers (32), two M10
Washers (24), and an M10 Nylon Locknut (26).
15
31
24
27
24
26
32
32
34
10
16. Attach the metal-sleeve end of the Long Cable
(34) to the M10 x 19mm Bolt (40) on the Weight
Carriage (13) with an M10 Nylon Locknut (26).
Do not overtighten the Nylon Locknut; the
Cable must be able to pivot freely.
17. Locate the Short Cable (33); note that there are
two balls on one end of the Short Cable and a
metal sleeve on the other end.
Lay the ball-end of the Short Cable (33) inside the
bracket on the Center Base (7). Attach a 3 1/2”
Pulley (27) inside the bracket using an M10 x
45mm Bolt (29) and an M10 Nylon Locknut (26).
18. Wrap the Short Cable (33) around a 3 1/2” Pulley
(27) as shown. Attach the Pulley and a Cable
Trap (39) to the Pulley Plates (28) with an M10 x
45mm Bolt (29) and an M10 Nylon Locknut (26).
19. Attach the Short Cable (33) to the Weight Base
(20) with an M10 x 75mm Bolt (31), two M10
Washers (24), two Long Spacers (41), and an
M10 Nylon Locknut (26).
16
17
18
19
34
33
29
27
28
39
26
33
31
20
41
26
24
24
41
33
26
29
27
7
13
40
26