Filter
Top Products
11
ATTACHING WEIGHTS TO THE LEG LEVER
To use the the Leg Lever (9) or Lat Tower (40), slide the
desired amount of weight (not included) onto the weight
tube on the Leg Lever or Weight Carriage (41). Secure
the weight on the Weight Carriage with the two Weight
Clips (52).
WARNING: Do not place more than
50 pounds on the Leg Lever (9).
9
40
41
52
Weight
Tube
52
ADJUSTING THE WEIGHT RESTS
To change the height of the Weight Rests (6), remove
your barbell from the Weight Rests. Then, remove
the Long Adjustment Knobs (27) from both Uprights (4,
5). Position the Weight Rests at the desired height, so
that the holes in the Weight Rests and the Uprights are
aligned. Fully tighten the Adjustment Knobs into the
Weight Rests and the Uprights.
WARNING: The Long Adjustment
Knobs (27) must be inserted through the Weight
Rests (6) and the Uprights (4, 5) and be firmly
tightened. Never tighten an Adjustment Knob into
an Upright before inserting the Weight Rest.
Always set both Weight Rests at the same height.
6
6
27
27
5
4
ATTACHING THE CURL POST
For some exercises, the Curl Post (13) or Lat Tower
(not shown) must be attached to the weight bench.
Insert the Curl Post (13) into the indicated hole in the
Front Leg (2). Align the holes in the Front Leg and the
Curl Post. Secure the Curl Post with the Short
Adjustment Knob (51). Make sure that you fully tight-
en the Adjustment Knob.
The Lat Tower (not shown) can be attached to the Front
Leg (2) in the same manner. Be sure that the Lat
Tower is oriented as shown on the front cover of
this manual.
See the inset drawing. When the Curl Pad (17) is not in
use, it can be stored in the tube on the Right Base (35).
51
13
17
2
17
35