Filter
Top Products
3
3
1
4
9
9
6
6
7
8
14
3. Attach one of the Front Uprights (7) and two Joint
Plates (6) to the Left Base (3) using four M10 x
80mm Bolts (4) and four M10 Nylon Locknuts (9).
Make sure the Front Upright is oriented so that
the holes on the bottom of the Front Upright
and the holes in the Joint Plates line up. If they
do not line up, turn the Front Upright upside-
down. Do not tighten the Nylon Locknuts yet.
Make sure the Front Upright is turned so the
adjustment holes are facing the Rear Upright
(8).
Attach the other Front Upright (7, not shown) and
two Joint Plates (6, not shown) to the Right Base
(1) in the same manner.
Tap a 60mm Square Inner Cap (14) into each of the
Front Uprights (7).
4. Attach the Chin-up Bar (13) and two Joint Plates (6)
to the Front Uprights (7) using four M10 x 80mm
Bolts (4) and four M10 Nylon Locknuts (9). Do not
tighten the Nylon Locknuts yet.
6
4
4
9
9
6
7
13
7
5. Press a 60mm Square Inner Cap (14) into the Left
Frame (12). Attach the Left Frame to the left
Uprights (7, 8) using four M10 x 80mm Bolts (4)
and four M10 Nylon Locknuts (9). Do not tighten
the Nylon Locknuts yet.
Assemble the Right Frame (10) to the right Uprights
(7, 8) in the same manner.
Attach the Center Frame (11) to the Left Frame (12)
and the Right Frame (10) using four M10 x 80mm
Bolts (4) and four M10 Nylon Locknuts (9).
9
14
9
4
4
4
4
10
11
12
9
9
5
7
8
8
7
6
4