Filter
Top Products
6. Lubricate the M10 x 178mm Bolt (31). Attach the
Backrest Frames (1, 2) to the Bench Frame (4) with
the Bolt, two M10 Washers (30), and an M10 Nylon
Locknut (27).
Secure the Backrest (3) in place by inserting the
Backrest Pin (16) through one of the sets of holes
in the Backrest Frames (1, 2) and through the hole
in the Bench Frame (4). Make sure the Backrest
Pin is completely inserted through both
Backrest Frames.
5. Press the four 1” Square Inner Caps (18) into the
ends of the Right and Left Backrest Frames (1, 2).
Press the two 1” x 2” Inner Caps (19) into the
adjustment tubes of the Backrest Frames.
Attach the Backrest (3) to the Backrest Frames (1,
2) with four M6 x 38mm Screws (35) and four M6
Washers (36). The Backrest Frames and the
Backrest must be oriented as shown.
5
7
4
4. Press two Weight Adapter Bushings (15) into the
ends of the Weight Adapter (14).
Press three 45mm Square Inner Caps (20) into the
Leg Lever (9). Press a 1” Round Inner Cap (24) into
the indicated end of the Weight Tube (10). Insert
the Weight Tube into the Leg Lever and press an
Angled Cap (25) onto the other end of the Weight
Tube. Secure the Weight Tube using an M8 x
58mm Bolt (37), two M8 Washers (29), a 10mm
Spacer (38), and an M8 Nylon Locknut (28).
Lubricate an M10 x 68mm Bolt (40). Attach the Leg
Lever (9) to the bracket on the Bench Leg (8) with
the Bolt and an M10 Nylon Locknut (27). Do not
overtighten the Nylon Locknut; the Leg Lever
must pivot freely.
3
21
4
27
34
12
21
6
20
14
15
15
9
25
28
29
38
37
20
24
10
20
40
8
27
18
18
18
18
19
19
1
Wide End
3
2
36
36
36
36
35
35
35
35
31
30
27
30
16
3
1
2
4
3. Press a 51mm x 76mm Outer Cap (21) onto each
end of the Bench Base (12).
Attach the Bench Base (12) to the Bench Frame (4)
using two M10 x 58mm Carriage Bolts (34) and two
M10 Nylon Locknuts (27).