Filter
Top Products
4
6
3. Attach the Storage Tube (51) to the Right Base
(7) with two M8 x 35mm Carriage Bolts (36) and
two M8 Nylon Locknuts (43).
Press a 45mm x 38mm Bushing (23) onto the
Left Upright (4). Slide a Weight Rest (6) into the
Upright and secure it at the desired height with a
54mm Adjustment Knob (27).
Secure the other Weight Rest (6) to the Right
Upright (5) in the same manner. Be sure that
both Weight Rests are set at the same height.
3
6
6
5
4
27
23
23
27
36
7
43
43
51
4. Press two 38mm Square Inner Caps (32) into the
ends of the Leg Lever (9). Press two 25mm
Round Inner Caps (21) into the ends of the
weight tube.
Insert four 19mm Round Inner Caps (47) into the
ends of two Pad Tubes (48). Slide the Pad Tubes
into the holes at the ends of the Leg Lever (9).
Slide four Foam Pads (33) onto the ends of the
Pad Tubes.
33
32
Weight
Tube
32
33
33
21
33
47
47
47
47
48
48
21
9
5. Lubricate the M10 x 67mm Bolt (46). Attach the
Leg Lever (9) to the Front Leg (2) using the Bolt
and an M10 Nylon Locknut (45). Do not over-
tighten the Nylon Locknut; the Leg Lever
must be able to pivot easily.
Press two 19mm Round Inner Caps (47) into the
ends of a Pad Tube (48). Slide the Pad Tube
through the hole in the Front Leg (2). Slide a
Foam Pad (33) onto each end of the Pad Tube.
5
33
33
46
Lubricate
9
45
47
47
48
2