Filter
Top Products
8
ADJUSTING THE BACKREST
The Backrest (7) can be used in a declined, a level,
or any of three inclined positions. To adjust the
Backrest, remove the Locking Pin (21) from the
Frame (1). Move the Backrest to the desired position
and reinsert the Locking Pin into the Frame and an
adjustment hole in the Pivot Bracket (6).
7
21
6
1
Adjustment
Holes
ADJUSTMENTS
7. Attach an M8 x 25mm Bolt (29) to the the last
hole in the Pivot Bracket (6) with an M8 Nylon
Locknut (27).
Press four 19mm Round Inner Caps (11) into the
two Pad Tubes (10).
Slide the two Pad Tubes (10) into the Front Leg
(2). Slide four Foam Pads (9) onto the ends of the
Pad Tubes.
8. Make sure all parts are properly tightened
before you use the slant board.
7
9
9
2
9
9
11
27
29
6
11
10
This section explains how to adjust the slant board. See the EXERCISE GUIDELINES on page 9 for important
information about how to get the most benefit from your exercise program. Also, refer to the accompanying exer-
cise guide to see the correct form for each exercise.
Make sure all parts are properly tightened each time you use the slant board. Replace any worn parts immediately.
The slant board can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.
WARNING: Always make sure the
Locking Pin (21) is fully inserted through the
Frame (1) and the Pivot Bracket (6).