Filter
Top Products
5. Insert the Support Rod (14) into a set of holes in
the Uprights (1). Turn the Support Rod so the
l
ocking pin is wrapped around the Upright.
T
ighten the M10 Nylon Locknuts (31) and M10
x 19mm Screw (5) used in steps 1–4.
1
1
1
4
5
8
6. Lubricate the M10 x 60mm Bolt (25) with part of
the included grease packet. Attach the Leg Lever
(6) to the Front Leg (4) with the Bolt and an M10
Nylon Locknut (31).
Do not overtighten the Nylon
Locknut; the Leg Lever must pivot easily.
7. Insert a Pad Tube (12) into the Leg Lever (6).
Slide a Foam Pad (13) onto each end of the Pad
Tube.
Repeat this step with the other Pad Tube (12).
6
13
13
12
12
Locking
Pin
25
31
Lubricate
6
4
6
7
8.
Insert a Weight Rest (15) into an Upright (1). Turn
the Weight Rest so the locking pin is wrapped
around the Upright.
Repeat this step with the other W
eight Rest
(15). Make sure that the Weight Rests are at
the same height.
15
15
Locking
Pin
1
1
8