Filter
Top Products
14
27. Locate the Low Cable (23). Route the Low
Cable under the 3 1/2Ó Low Pulley (102). Be
sure that the end of the Cable with the ball
is on the indicated side of the Press Frame
(17) and that the Cable is between the
Pulley and the crossbar on the Press
Frame. Tighten the 3/8Ó Nylon Locknut (21)
and the 3/8Ó x 3 3/4Ó Bolt (not shown).
28. Route the Low Cable (23) around the 3 1/2Ó
Pulley (15) attached to the lower hole in the
Front Upright (42). See the inset drawing.
Be sure that the Cable Trap (66) is turned
to hold the Cable in place and that the
Cable is routed around the Pulley as
shown. Tighten the 3/8Ó Nylon Locknut (21)
and the 3/8Ó x 3 3/4Ó Bolt (88).
29. Route the Low Cable (23) around the 3 1/2Ó
Pulley (15) attached to the upper hole in the
Press Frame (17). Be sure that the Cable
Trap (66) is turned to hold the Cable in
place and that the Cable is routed around
the Pulley as shown. Tighten the 3/8Ó Nylon
Locknut (21) and the 3/8Ó x 3 1/2Ó Bolt (not
shown).
30. Route the Low Cable (23) around the 3 1/2Ó
Pulley (15) attached to the upper hole in the
Front Upright (42). See the inset drawing.
Be sure that the Cable Trap (66) is turned
to hold the Cable in place and that the
Cable is routed around the Pulley as
shown. Tighten the 3/8Ó Nylon Locknut (21)
and the 3/8Ó x 3 3/4Ó Bolt (88).
30
27
23
28
Inset shows view
from other side
29
CABLE ASSEMBLY
21
17
Ball
42
88
23
23
21
15
15
42
66
Inset shows view
from other side
42
88
23
23
15
15
66
42
21
23
17
66
15
102
Crossbar
21