Filter
Top Products
ATTACHING WEIGHTS TO THE LEG LEVER OR
THE FLY ARMS
To use the Leg Lever (4), slide the desired weights
onto the weight tube on the Leg Lever.
To use the Fly Arms (25), make sure there is a
Weight Stop (28) on each weight tube. Then, slide the
desired weights onto the weight tubes.
ADJUSTING THE BACKREST
The Backrest (6) can be used in a declined position,
a level position, or any of three inclined positions. To
use the Backrest in a declined position, remove the
Backrest Support (7) and lay the Backrest on the
Crossbar (3).
To use the Backrest (6) in a level position or an
inclined position, insert the Backrest Support (7) into
a set of holes in the Uprights (1). Rotate the Backrest
Support to the locked position, with the locking pin
wrapped around the left Upright. Rest the Backrest on
the Backrest Support.
1
1
7
4
28
25
3
Weight
Tube
Weight
6
Locking
Pin
Weight
Tube
Weight
10
WARNING:
When using the
Leg Lever (4), place a barbell with the same
amount of weight on the weight rests to
balance the bench.
Do not place more than
50 lbs. (23 kg) on the Leg Lever. Do not place
more than 30 lbs. (14 kg) on each Fly Arm (25).
ADJUSTMENT
The steps below explain how the weight bench can be adjusted. See the accompanying exercise guide to see
the correct form for several exercises.
Make sure all parts are properly tightened each time the weight bench is used. Replace any worn parts immediately.
The weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent; do not use solvents.