Filter
Top Products
13
24. Wrap the Long Cable (23) around a 3 1/2” Pulley (15)
in the direction shown.
Attach the 3 1/2” Pulley (15) and a Cable Trap (66) to
the indicated hole in the welded bracket on the Base
(4) with a 3/8” x 2” Bolt (12) and a 3/8” Nylon Locknut
(21). Note: Make sure the Cable Trap is oriented
as shown.
24
12
15
21
23
66
4
25. Wrap the Long Cable (23) around a 3 1/2” Pulley (15)
in the direction shown.
Attach the 3 1/2” Pulley (15) to the indicated side of
the Pulley Bracket (57) by using the 3/8” x 2 1/2” Bolt
(60) and the 3/8” Nylon Jamnut (22) attached in step
21. Note: Make sure the Pulley Bracket is oriented
exactly as shown and that the Pulley is attached
on the indicated side.
25
15
57
23
26. Wrap the Long Cable (23) around a 3 1/2” Pulley (15)
in the direction shown.
Attach the 3 1/2” Pulley (15) to the indicated side of
the Upright (42) with a 3/8” x 3” Bolt (72), a 3/8” Flat
Washer (9) and a 3/8” Nylon Jamnut (22). Note:
Make sure the Long Cable is between the Pulley
and the Spacer on the Upright/Base.
26
22
Spacer
42
72
23
15
9
23. Wrap the Long Cable (23) around a 3 1/2” Pulley (15)
in the direction shown.
Attach the 3 1/2” Pulley (15) and a Cable Trap (66) to
the to the lower hole in the “I”-Plates (20) with a 3/8”
x 2” Bolt (12) and a 3/8” Nylon Locknut (21). Note:
Make sure the Cable Trap is oriented as shown.
23
21
66
15
12
20
23
22
60