Filter
Top Products
7. Tap two 19mm Round Inner Caps (9) into each
Long Pad Tube (10). Slide the Pad Tubes through
the holes in the Leg Lever (4). Slide two Long
Foam Pads (23) onto each Pad Tube.
8. Tap two 25mm Square Inner Caps (35) into each
of the two Backrest Tubes (5).
Attach each Backrest Tube (5) to the Backrest (6)
with two M6 x 38mm Screws (30) and two M6
Washers (26). Note: Do not tighten the Screws
yet.
9. Tap a 19mm Round Inner Cap (9) into each end
of the Support Rod (7). Insert the Support Rod
through a set of holes in the Uprights (1). Rotate
the Support Rod to the locked position, with the
locking pin wrapped around the Upright.
Lubricate the M10 x 135mm Bolt (36). Attach the
Backrest Tubes (5) to the welded tube on the
Frame (2) with the Bolt, two M10 Washers (34),
and an M10 Nylon Locknut (33).
Tighten the M6 x 38mm Screws (30) used in
step 8, and the Nylon Locknuts (17, 33) used
in steps 1–4.
10. Attach the Seat (11) to the brackets on the Frame
(2) with four M6 x 16mm Screws (29).
9
10
10
9
4
23
23
7
7
8
5
30
26
26
30
6
35
35
9
9
9
34
5
36
7
1
2
Welded Tube
1
Locking
Pin
33
34
10
11
29
2