Filter
Top Products
To open the OSD, press the Control
Wheel once to display the OSD
Selection Menu. Rotate the Control
Wheel to highlight the icon representing
the parameter you wish to adjust and
press the Control Wheel to select that
parameter. Rotate the Control Wheel to
adjust the value. When you are satisfied,
press the Control Wheel to return to the
OSD Selection Menu.
You will see the follwing display in your
iWear
®
AV920.
OSD
Icon
Effect
LCD Brightness
Contrast
Video Mode Control 2D/3D
Backlight Brightness
Reset to factory defaults
Exit OSD
To exit the OSD, select the OSD Exit
icon or wait 3-5 seconds.
Monoscopic 2D and Stereo 3D Modes
When using stereoscopic 3D content it
may be necessary to adjust the iWear
®
AV920 3D mode. When viewing 3D
content in 2D mode it will look fuzzy
on the display. If this happens, adjust
viewing mode from 2D to 3D stereo
mode by pressing the Contol Wheel
on the Video Mode Contol 2D/3D icon
in the OSD and then select one of the
three options. Make sure you select the
appropriate 3D mode so that each video
display has the correct left and right eye
information.
It is recommended to use 2D mode for all
non 3D content. Although you can view
2D content in 3D mode the resolution is
cut in half and there will be differences in
the video to each eye.
Cleaning
Use a soft dry cloth to clean your iWear
®
AV920 and its optics. Do not use liquid
cleaners.
Updating
Your iWear
®
AV920 is fully field
upgradable to ensure that you have the
best experience possible. To upgrade
your iWear
®
AV920 firmware or to
download updated software, please visit
www.vuzix.com/support.
6