Vision Fitness X6200HRC/DA Elliptical Trainer User Manual


  Open as PDF
of 7
 
621-D East Lake Street • P.O. Box 280 • Lake Mills. WI 53551
toll free 1.800.335.4348 • phone 1.920.648.4090 • fax 1.920.648.3373
www.visionfitness.com
2000 Vision Fitness. All Rights Reserved. 8.00 Part #Z60EP08-AG1801PRD
AG18.01PRD
REV1
the vision to succeed
5
STEP
7
5
STEP
• Slide a large spring washer
(M26 x 34 x .3T) onto the console
mast axle. Locate and slide the right
upper handlebar bracket onto the
console mast axle and attach with a
washer (M8 x 35 x 2T) and 13
MM
NyLock nut, using the 13
MM
wrench.
Snap the plastic 13
MM
nut caps over
the nuts.
• Slide a small spring washer
(M16 x 22 x .3T) onto the lower
pedal arm support, followed by the
right lower arm. Attach with a washer
(M8 x 25 x 1.5T) and bolt (M8 x 12),
using the Blue 5
MM
Allen wrench.
• Pivot the lower arm and insert the
top end into the upper handlebar
bracket. Attach with bolts (M7 x 35)
and (M8 x 12) through the side, and
bolts (M8 x 16) from the front. Tighten
using the Blue 5
MM
Allen wrench.
• Repeat the above steps to attach the
left-hand upper and lower arms.
GREEN BAG
 previous