Filter
Top Products
5
STEP
Link Arm
Covers
Dual-Action
Axle Cover
Footplate
Dual-Action
Arm
Console
Mast Axle
9
5
STEP
• Slide the dual-action axle cover into
place over the console mast axle.
Slide a wavy washer (25x34x2T)
onto the console mast axle. Slide the
right dual-action arm onto the axle. Fix
in place with a washer (8x38x2T)
and nylon nut (M8). Cover with the
included nylon nut cover.
• Insert the link joint sleeve (SS41)
into the socket joint of the right link
arm. Position the socket joint of the
link arm into the bracket at the bottom
of the dual-action arm. Position the
Nylon Interval Rings between the
socket joint and bracket on each side.
Insert a screw (M8x45L) through the
bracket, interval rings and socket joint
sleeve. Secure in place with a washer
(8x25x1.5T) and nylon nut (M8).
Tighten with the 5mm T-shaped
wrench and 13mm wrench.
• Position the link arm covers over the
socket joint and secure the two pieces
together with a screw (M4x12L).
Tighten with the screwdriver. Connect
the cover to each side of the link arm
with a washer (5x10x1T) and screw
(M5x10L). Tighten with the
screwdriver.
• Position the right footplate onto the
right link arm. Secure in place with
four washers (6x14x1T) and four
screws (M5x10L). Tighten with the
screwdriver.
• Repeat steps on the left side.
BLACK BAG