Filter
Top Products
5
1
STEP
1
STEP
• Slide the rubber covers on to the left
& right console supports, making sure
that the lower cutout is facing inward.
T9700-Series: Slide the data cable
down the right console support using
the white wire tie as a guide. Make
sure that the data (1 large ribbon
cable) goes through the large hole in
the lower part of the console upright.
T9200, T9300HRT, T9500HRT,
T9500HRT Ortho & T9600HRT
Comfort: Slide the data cables down
the right console support using the
white wire tie as a guide. Make sure
that the data cables (one small & one
large telephone-style cable) go
through the large hole in the lower
part of the console upright.
• Insert the left console support into
the console support bracket and
secure with two bolts (M8 x 55L
Flathead) in the side of the console
support bracket.
• Insert one bolt (M8 x 20L) in the
rear of the console support bracket.
• Tighten all three bolts with the 5mm
Allen wrench.
• Repeat this on the right side.
NOTE: There are no data cables on
the left side.
ORANGE BAG