Filter
Top Products
5
1
STEP
• Install the rear foot with the four lock
washers (M8), two inside screws
(M8x65L), and two outside screws
(M8x20L). Tighten with the 5
MM
Allen
wrench.
ORANGE BAG
1
STEP
2
STEP
• Slide the rubber boot onto the
console mast.
• Locate the bundle of wires that
comes from the console mast frame
bracket. Wrap the wire tie coming
from the bottom of the console mast
around the bundle of wires. Pull the
wire tie with the bundle of wires up
through the top of the console mast
while simultaneously sliding the mast
into the frame bracket.
• Secure the console mast to the
frame bracket with six lock washers
(M8) and six screws (M8x15L).
Tighten with the 5
MM
Allen wrench.
Place the seventh screw (M8x15L) in
the rear of the frame bracket and
tighten until snug.
• Slide the console mast boot down
and snap it into place on the side
cover.
• Remove the screws located half
way up the console mast with the
Phillips screwdriver. Attach the water
bottle bracket to the console mast with
these two screws. Insert the water
bottle.
BLUE BAG
2
STEP