Filter
Top Products
5
2
STEP
• Slide the rubber boot onto the
console mast.
• Unfold the wire harness and heart
rate wires located in the console mast
frame bracket. Attach the wire tie
coming from the bottom of the console
mast to the wire harness and heart
rate wires. Pull the wire tie with wire
harness and heart rate wires up
through the top of the console mast
while simultaneously sliding the mast
into the frame bracket.
• Secure the console mast to the
frame bracket with six lock washers
(M8) and six screws (M8x15L).
Tighten with the 5
MM
Allen wrench.
Place the seventh screw (M8x15L) in
the rear of the frame bracket and
tighten until snug.
• Slide the console mast boot down
and snap it into place on the side
cover.
• Remove the screws (M8x15L)
located half way up the console mast
with the Phillips screwdriver. Attach
the water bottle bracket to the console
mast with these two screws. Insert the
water bottle.
BLUE BAG
1
STEP
• Install the rear foot with the four lock
washers (M8), two inside screws
(M8x65L), and two outside screws
(M8x20L). Tighten with the 5
MM
Allen
wrench.
ORANGE BAG
1
STEP
2
STEP