Filter
Top Products
7
3
STEP
R2200HRT
Only
R2200 Only
3
STEP
• Slide the console mast cover over
the console mast. Guide the console
cable up through the bottom of the
console mast with the attached wire.
• Slide the console mast into the con-
sole mast mounting bracket and use
the 5
MM
Allen wrench to secure the five
screws (M8x15L) and lock washers
(M8). Note: The screw facing the seat
does not use a lock washer. Tighten
this screw only until snug.
• Slide the console mast cover to the
proper position. Attach the front
handlebar to the console mast. Use
the 5
MM
Allen wrench to tighten the two
screws (M8x20L) and lock washers
(M8) to secure the handlebar.
• Take out the four screws (M5x12L)
from the back of the console with the
Phillips screwdriver. To attach the
console, plug in the console cable to
the proper position in the back of the
console. Reinsert the four screws
(M5x12L) with the Phillips screwdriver
to secure to the console mast.
• Use the Phillips screwdriver to
attach the water bottle cage to the
console mast with the two included
screws (M5x15L). Insert the water bottle.
PINK BAG