Filter
Top Products
8
Clears a live entry by pressing this key once. Press twice to clear the
accumulator or pending calculation. Does not clear the Memory or Grand total.
18. [
÷] Division key
To divide, enter the number to be divided (dividend) then depress the Divide key.
Then enter the second number (divisor) and depress Equals or other keys as
necessary to obtain a result. If the key is depressed repeatedly, it will make
sequential division calculations.
19. [=] Equal key
To get the result in multiplication or division.
20. [X] Multiplication key
To multiply, enter the first number (multiplicand) and depress the Times key.
Then enter the second number (multiplier) and depress Equals or other keys as
necessary to obtain a result. If the key is depressed repeatedly, it will make
sequential multiple calculations.
21. [+/-] Sign change key
Reverse the sign on the display.
22. [0]-[9], [00] & [•] Numeric keys.
Any numeral over 12 digits will be ineffective. When decimal point key is used
more than once in one numeral, the first decimal point will be considered as
effective.
23. [−] Minus key
Subtracts an amount from the accumulator. To subtract the same amount more
than one time (repeat subtraction), enter that amount once and depress the
Minus key as many times as necessary. If this key is depressed immediately
after [%] key, it works as percent minus key.
24. [+] Plus key
Adds an amount to the accumulator. To add the same amount more than one
time (repeat addition), enter that amount once and depress the Plus key as
many times as necessary. If this key is depressed immediately after [%] key, it
works as percent plus key.
25. [TIME/DATE] Time and Date display key
Used to display or program the date and time. Depressing this key once will
cause the date to display, a second depression will display the time. Holding the
key down for three seconds will cause the date or time to flash, this is the
program mode.
26. [N] Item Count key
Calculations with item count.
27. [# / S]
Date / Subtotal key
#: Prints the entered figure as an identifier or invoice number with the “#”
symbol.
S: Prints a Subtotal of the numbers in the accumulator without clearing the
accumulator. Used if the operator needs to see what’s in the accumulator, then