Filter
Top Products
8. Grasp the Tube Socket and push on the fluorescent tube base to disconnect
the tube from the socket.
9. Do not allow the tube to drop.
10. Follow local procedures for safe fluorescent tube disposal.
7.2. FLUORESCENT TUBE INSTALLATION
1. Make sure that the Lantern Switch is Off.
2. Press the new fluorescent tube’s base into the Tube Socket Assembly.
3. Replace the Tube Socket Assembly so that the two Support Rods pass
through the assembly and it is fully seated against the clear plastic dome.
4. Replace the two nuts and tighten (clockwise) so that the tube assembly is snug.
5. Screw on (clockwise) the End Cap until it is snug.
6. Test the fluorescent tube for proper operation by reconnecting the battery
and turning On the Lantern switch.
8. FUSE REPLACEMENT
The fuse is located inside the DC plug. See Figure 5 for fuse replacement.
Make sure the DC Recharger connector is disconnected from the SportSpot Lantern.
FUSE REPLACEMENT PROCEDURE
1. Unscrew (counterclockwise) the flange from the DC plug
2. Remove the flange, contact and fuse from the plug assembly.
3. Replace fuse with a 10 -ampere fuse of same type and size.
4. Place the center contact in the flange.
5. Replace the center contact and flange on the DC plug.
6. Tighten (clockwise) until the flange is fully seated.
DO NOT OVERTIGHTEN FLANGE
9. BATTERY REPLACEMENT
The battery is contained in a compartment in the base of the unit. A plate must
be removed to gain access to the battery. Figures 5A and 5B show access to
the battery compartment.
1. INTRODUCTION
Congratulations on purchasing the Vector SportSpot Lantern, an advanced
design combination spotlight and lantern. It instantly converts use from a
powerful spotlight to a soft, long-lasting area light. See Figure 1A and 1B. It
uses a powerful proven-technology, rechargeable, sealed lead acid battery that
allows for years of dependable use, recharge after recharge. It was designed
from the ground up to be the most versatile and practical light for travel,
camping, picnicking, tailgate parties and boating. The SportSpot Lantern gives
you the kind of light you need, when and where you need it.
FIGURE 1A FIGURE 1B
Two recharge adapters are supplied with the SportSpot Lantern. It is recharge-
able from either a DC cigarette lighter type 12-volt DC socket (accessory
socket) or from any 110/120 volt 60 Hz AC receptacle. This permits recharge
flexibility for use around home, business or in the field. The unit may be oper-
ated during DC recharge from any 12 volt accessory socket able to supply at
least 5 Amperes. This feature allows for uninterrupted use when the unit’s
internal battery becomes discharged and requires recharging. 12 volt DC
power is available from most vehicles, boats, jump starters and portable
battery packs. Vector has a variety of portable power products that may be
considered as companions to your SportSpot Lantern. Contact Vector for addi-
tional information.
16
FIGURE 5A FIGURE 5B
SPOTLIGHT ON/OFF
LANTERN SWITCH
RECHARGE LEDS
90°
SPADE CONNECTOR
SPADE
CONNECTOR
SWITCH
BATTERY
AC/DC
RECHARGE
BARREL
RECEPTACLE
SPADE
LUG
TERMINALS
BATTERY
COMPARTMENT
COVER
TAB
FLANGE CONTACT
FUSE
SPRING PLUG