Filter
Top Products
GB
OWNER’S MANUAL
•
S90
3
ASSEMBLY
The parts are packed in two separate packages.
Check that all the following parts are in the
packages:
1. H-frame
2. Vertical frame
3. Shocks (2)
4. Handlebars (3)
5. Meter
6. Assembly kit (contents marked with in the
spare part list): keep the assembly tools, as you
may need them e.g. for adjusting the equipment.
If you notice that a part is missing, contact the
dealer and give the model (S90), serial number
and spare part number from the list at the back
of the manual. The package includes a silicate
bag for absorbing moisture during storage and
transportation. We recommend two persons for
the assembly. Assemble the device as follows
(left, right, front and back are as seen from the
exercising position):
H-FRAME AND VERTICAL FRAME
Place the plastic insulation plate between the
vertical and the H-frame. Insert 4 M8x55 mm
button head bolts up through the bottom of the
H-frame. Place the vertical frame over the bolts.
Add a washer to each bolt and secure each using
the 5 mm hexagon key and the 13 mm open-end
wrench and the M8 lock nut provided. Lift the
climber back into the upright position.
SHOCK ABSORBERS
Attach the end of the shock absorber that
contains the resistance adjustment mechanism to
the left side of the vertical frame. Slide the end of
the shock absorber and a suitable spacer over the
shock mount shaft on the left side of the vertical
frame. Secure with the M8x40 mm button head
bolt and lock washer using the 5 mm hexagon
key provided. Attach the right shock absorber in
the same manner.
Slide a metal spacer inside the ring on the bottom
of the shock absorber. Fasten the ring to the
bracket on the left foot pedal with the M8x40
mm button head bolt and with the M8 lock nut.
Use the 13 mm open-end wrench to hold the
nut while you tighten the bolt with the 5 mm
hexagon key provided.
NOTE! Be careful not to
overtighten the bolt as this may crack the plastic
bushing. Attach the right shock absorber to the
right foot pedal in the same manner.
HANDLEBARS